BI6206 High Power Laser Burn-In System-Semight Instruments

Laser Diode Burn-in

BI6206

High Power Laser Burn-In System

BI6206 is a High-power Burn-In system for high power laser diode, such as VCSEL for 3D sensor, pump laser for fiber communication, High power EEL laser for laser display and so on.

BI6206 provide current up to 10A per channel. The whole system support total 512 channels, this makes it a good solution for large volume production.

BI6206 also provide in-situ optical power monitoring, this makes it a good solution for R&D life test of high-power laser.

Datasheet

Apply for prototype

Feature

High power
Up to 10A CW laser chip driver per channel;
High-capacity
Whole system support total 512 channels high volume burn-in；
Good temperature uniformity and high accuracy
Temperature controlled by TEC + cooling water
Could support burn-in temperature as low as 0℃
Easy to operate
Different laser diode only needs to change fixture
EOS free under any condition and operation

Functions and advantages

Optimized design of test fixture
Burn-in drawer and Burn-in fixture type

System index	System Size	1500L1250W2000H(mm)
	Drawers quantity	Up to 32 drawers
	System capacity	512pcs
	System temperature zone	Each drawer working independently
	Power Requirement	380V 50/60Hz 120A, 3-phase electricity
	Nitrogen demand	Protection laser option
	Supported laser types	Any laser, drive current < 10A
	Probe card accuracy	<50μm
	MES Interface	Support any MES relative requirement customer wants
	Data storage	Raw data and calculated parameter, data file and database

Similar recommendation

Optical Network Test

Optical communication network plays an important role in the rapid development of big data, cloud computing, 5G communication and other markets.
Semight Instruments offers various of instruments for optical Transceiver/Component testing, including wide bandwidth sampling oscilloscope, NRZ/PAM4 bit error ratio tester , burst error ratio tester, fast wavelength meter, optical spectrum analyzer, high precise source measure unit, 400G network analyzer ,optical power meter, optical attenuator, optical switch etc. Provide cost-effective complete solutions.

Details

Electronic Measurement

The high-precision source meter integrates the functions of voltage source, current source, voltmeter, ampere meter, and electronic load in one, which is widely used in high-precision IV test and measurement for various discrete components, photovoltaic, new energy, battery and other industries. Semight Instrument provides high-precision benchtop source meters and plug-in PXIe source meter modules of standard PXIe chassis, fully meeting the application of various test scenarios.

Details

Optical Chip Test

Burn-in testing of laser is an important method to ensure the reliability of laser. Through the test of COC or bare die, the early failure of laser caused by the defects in the process of laser production can be screened out in advance. Semight Instrument provides a complete solution from bare die to COC, from high temperature(150℃ or higher) to low temperature (-40℃), with CoC automatic loading and unloading system, forming a complete test solution, Semight Instrument's laser chip burn-in/load/unload test system has been widely recognized by the market.

Details

Power Semiconductor Test

The semiconductor front-end test is mainly used in the wafer processing to check whether the processing parameters of the wafer products meet the design requirements or there are defects affecting the yield after each step of the manufacturing process. The semiconductor back-end test equipment is mainly used after wafer processing to check whether the performance of the chip meets the requirements, which belongs to the electrical performance test. Semight Instrument provide integrated solutions such as wafer burn in and known good die tester, improve test efficiency and reduce test cost.

Details

Site Map